- Package Contents：09985 Pressure canner sealing ring Comes with overpressure plug (pack of 2)
- 09985 Pressure canner sealing ring Compatible with Presto pressure cookers or canners. Fits into cover and forms a pressure tight seal between the cover and the body during cooking.
- Compatibility: The pressucanre ner sealing ring Replacement for 09985 Presto parts Compatible with Presto pressure canner models 0174510, 0178107, 0175107, 0175510, 0178410.
- Easy to install: Wash the gasket groove thoroughly before installing, soak the pressure cooker gasket in warm water for 10 minutes to increase flexibility, insert the gasket and press it firmly into the groove.
- Note: Compatible with Presto pressure cooker models only. Please confirm whether the product size and model match your pressure cooker before purchasing.
Product Description
Compatible Products
0174510 16-Quart Pressure Canner
0175107 18-Quart Pressure Canner
0175510 16-Quart Pressure Canner
0178107 23-Quart Pressure Canner
0178209 23-quart Pressure Canne
The Pressure Can Sealing Ring Fits Around The Inside Edge Of The Lid AndCreates A Pressure Seal Between TheLid And The Body Of The Pressure CanDuring Canning And Cooking
Installation:
1:Remove the old used seal and overpressure plug.Thoroughly clean pressure cooker seal ring grooves and overpressure plug holes.
2:Wash the new sealing ring and overpressure plug withwarm soapy water, and then dry thoroughly. Installthe sealing ring until it is fully seated. Make sure toinstall it under the stopper and lock pin, at the inneredge of the cover.
3:If necessary, to help make the cover easier to open and close, a very light coating of cooking oil may be applied to the underside of the body lugs and sealing ring.
4:Install the overpressure plug, push the side of theplug (marked “TOP”), enter the opening from thebottom of the cover. The indented part of the plug canbe seen from the underside of the cover.
5:When the lid is lightly placed on the body of the pressure cooker, press Once installed, open and close the lid a few times to make sure the ring is fully seated.